Attaching A Metal Trellis To Siding

Place 2 inch deep by 4 inch wide 5 by 10 cm boards on the sides of the trellis.

Attaching a metal trellis to siding.

Use long metal fence posts pounded in ground not too close to house so damages to not incur to siding or foundation from vines also keeps bugs rodents from climbing up trellis onto house then attach the trellis to the metal posts using metal brackets these will provide adequate support for trellis plants on trellis and protection from the wind or storms knocking it over up against house causing damages posts at each side section of trellis if you are putting them beside each other depending. Drill holes and screw the boards for the trellis into place. See the steps below. In the past i ve talked about how much i loved using siding hooks to hang trellises onto your siding covered house.

Personally i d try to avoid any holes in the siding. Attaching your trellis to studs will make it more secure. Dig a couple holes and make posts to attach the lattice to. There are at least three alternative ways to do it.

This renders the siding vulnerable to moisture and voids the warranty even if you seal the hole. Choose a side of the structure that receives the right amount of sunlight per day for your plants or flowers. Attach the trellis to the 4 inch side of the boards to. If your trellis is large or heavy you may need a helper to install.

If you want to hang something from your vinyl siding don t even think about drilling through it to attach a hook to the sheathing. I don t want to just start drilling holes only to find out i ve caused some problem with the integrity of the siding. Line the edges of the trellis up with these marks as best as you can. And i still do love them because they can easily be installed removed and they don t put any holes into your siding.

Then mark screw locations on both the wall and trellis. If you look closely you can see the angle bracket and bolt in the picture. Screw two by fours to the back of the trellis using 3 inch wood screws and a power drill if the trellis would rest flat against the wall. Hang a metal trellis on a vinyl wall using screw in plant hooks in pvc pipe sections and hang the trellis on the hooks.

I just moved into a house with vinyl siding which i ve never had before. Installing a trellis onto the side of your house is actually quite simple. Of course this is california and we don t do soffits which makes it easier. I have a few trellises made of painted wood.

Use a stud finder available from home improvement stores to find and mark the locations on the wall with a pencil. Stabilize the trellis in its position.