Reposition the shutter.
Attaching wood shutters to vinyl siding.
Overtightening fasteners during shutter installation can create warping or dimples on the surface of vinyl.
How to attach shutters to vinyl siding.
To remove shutters do not attempt to pull out the shutter spikes.
Push shutter locks through the holes in the shutter and into the hole in the wall surface.
Measure the thickness of the shutter.
Tap the shutter fastener gently with a hammer to snug the shutter against the siding.
Then proceed to one of the next two steps.
Help support our channel by supporting yourself with suggested items below.
Do not over tighten or this will cause the shutter to dimple.
Shutters first then apply shutter to shield their knowhow 3m exterior command hook under the starter strip it in place them near the different styles of the vinyl and latch.
Measure the thickness of the lap on the siding.
Most vinyl siding is made to imitate wood lap siding so the lap of the siding is.
Add these two measurements together then add 1 2 inch.
Grasp the shutter fastener supporting shank and push it through the shutter hold and into the wall surface.
For wood vinyl or aluminum siding drill a 5 16 diameter hole through the siding.
We are an affiliate for amazon and ebay.
But the only way to fasten the shutters is to drill into the siding.
After removing the shutter drill a hole at each mark.
Approximately 5 inches from the shutter s top is an ideal location for screws.
Measure the same distance upward from the bottom of your shutters and make a mark on your siding for the next screw.
Be careful not to drill into the wall.
Purchasing items though our links will n.
Mark the locations of the mounting holes on the building.
So i don t really want to do that because if it doesn t work out then i have holes in my siding.
Use a hammer to gently tap the fasteners to snug the shutter to the siding.