The model building codes allow both vented and unvented roof assemblies.
Attic structure definition.
Horizontal line at the top of the roof.
Another factor that determines whether you can convert your attic is the presence of roof rafters vs.
This article describes and illustrates the different types of support that prevents roof sagging and wall bulging at buildings including definitions of collar ties rafter ties and structural ridge beams.
Eaves are the edges of a roof typically overhanging the vertical exterior walls of a building.
Attic in architecture story immediately under the roof of a structure and wholly or partly within the roof framing.
Traditional rafters look like triangles.
Attics or roofs can be designed and constructed to be either vented or unvented in any hygro thermal zone map 1.
Roof rafters or trusses.
A structure located behind the higher side of a chimney or similar projections from the roof to divert rainwater around it.
Utilized by the ancient romans principally for decorative purposes and inscriptions as in triumphal arches it became an important part of the renaissance facade often enclosing an additional story the windows of which became part of the decoration.
Originally the word denoted any portion of a wall above the main cornice.
Domestic roof construction is the framing and roof covering which is found on most detached houses in cold and temperate climates.
Such roofs are built with mostly timber take a number of different shapes and are covered with a variety of materials.
Collar ties rafter ties tension beams structural ridge beams.
Some of these can support the roof and prevent ridge sagging and wall spreading.
The structure is a series of trusses beams and rafters that give the roof its shape and that the roof sheathing is laid upon.
The v cut angle along the junction of two slopes of a roof.
The truss is the skeleton of a roof made of a series of parallel beams.
When you see a home under construction and see lumber connected on top of the main housing structure you are looking at the roofing structure.
First is the frame of the roof structure.
The rafters are the supporting beams that run from the apex to the bottom of a roof holding up the truss.
In some applications this is preferable to a braced frame system which would leave some areas obstructed by the diagonal braces.
Trusses look like triangles with smaller triangles inside of them the boards forming these small triangles are called chords and webs.
An l shaped metal strip positioned along a roof s edges to allow water to run off the roof without running down the eaves or siding.
